Search for: All records

In contrast to the large volume of studies on the impact of horizontal resolution in oceanic general circulation models (OGCMs), the impact of vertical resolution has been largely overlooked and there is no consensus on how one should construct the vertical grid to represent the vertical structure of the baroclinic modes as well as the distribution of distinct water masses throughout the global ocean. In this paper, we document the importance of vertical resolution in the representations of vertical modes and water masses in the North Atlantic and show i) that vertical resolution is unlikely to undermine the resolution capability of the horizontal grid in representing the vertical modes and a 32-layer isopycnal configuration is adequate to represent the first five baroclinic modes in mid-latitudes and ii) that vertical resolution should focus on representing water masses. A coarse vertical resolution (16-layer) simulation exhibits virtually no transport in the dense overflow water which leads to a weaker and significantly shallower Atlantic meridional overturning circulation (AMOC) despite resolving the first baroclinic mode throughout the domain, whereas there are overall very small differences in the subtropical and subpolar North Atlantic circulation in the simulations with finer vertical resolution (24 to 96 layers). We argue that accurately representing the water masses is more important than representing the baroclinic modes for an OGCM in modeling the low-frequency large-scale circulation. 

In this study, we investigate the transition of semidiurnal Kelvin waves into Hybrid Kelvin-Edge (HKE) waves and associated generation of internal tides at widening shelves using theory, a realistic global baroclinic ocean model simulation, and quasi-realistic regional barotropic model simulations. Using the global model simulation, we identify several areas where a tidal HKE wave transition co-exists with internal wave generation. Of all areas considered, the Celtic Sea/Bay of Biscay shelf has the widest shelf and the strongest internal tide generation. We find that the global simulation agrees better with the theoretical Kelvin modes on the narrow than with the hybrid edge modes on the wide shelves. To help us understand the effect of complex, realistic bathymetry on the HKE wave transition, we perform quasi-realistic 1/25◦ barotropic simulations of the Celtic Sea/Bay of Biscay shelf areas. In these simulations, we gradually change the realistic bathymetry to a more idealized bathymetry. The idealized simulations show that the complex bathymetry steers the barotropic energy flux and causes standing wave patterns, which mask the HKE wave transition. Based on this analysis, we conclude that the HKE wave transition in the Celtic Sea/Bay of Biscay and other shelf areas in the global ocean is most likely masked by the effects of complex bathymetry and that offshelf baroclinic fluxes cannot be exclusively attributed to the HKE wave transition. 

The effects of horizontal resolution and wave drag damping on the semidiurnal M2 tidal energetics are studied for two realistically-forced global HYbrid Coordinate Ocean Model (HYCOM) simulations with 41 layers and horizontal resolutions of 8 km (H12) and 4 km (H25). In both simulations, the surface tidal error is minimized by tuning the strength of the linear wave drag, which is a parameterization of the surface-tide energy conversion to the unresolved baroclinic wave modes. In both simulations the M2 surface tide error with TPXO8-atlas, an altimetry constrained model, is 2.6 cm. Compared to H12, the surface tide energy conversion to the resolved vertical modes is increased by 50% in H25. This coincides with an equivalent reduction in the tuned loss of energy from the surface tide to the wave drag. For the configurations studied here, the horizontal and not the vertical resolution is the factor limiting the number of vertical modes that are resolved in most of the global ocean: modes 1–2 in H12 and modes 1–5 in H25. The wave drag also dampens the resolved internal tides. The 40% reduction in wave-drag strength does not result in a proportional increase in the mode-1 energy density in H25. In the higher-resolution simulations, topographic mode-scattering and wave–wave interactions are better resolved. This allows for an energy flux out of mode 1 to the higher modes, mitigating the need for an internal tide damping term. The HYCOM simulations are validated with analytical conversion models and altimetry-inferred sea-surface height, fluxes, and surface tide dissipation. H25 agrees best with these data sets to within 10%. To facilitate the comparison of stationary tide signals extracted from time series with different durations, we successfully apply a spatially-varying correction factor.